Navigator 4WD V8-5.4L DOHC VIN R (2001)
Speed Sensor: Service and Repair
Front Output Shaft Speed Sensor
Output Shaft Speed Sensor-Front
Removal
1. Remove the transfer case shift motor.
2. Remove the wire connector spacer and the front output shah speed sensor wire pins from the electrical connector.
^
Use the proper electrical connector pin remover.
3. Remove the front output shaft speed sensor.
1
Remove the bolt.
2
Remove the front output shah speed sensor.
Installation
1. CAUTION: Make sure the sensor seats flat against the boss.
To install, reverse the removal procedure.