Navigator 4WD V8-5.4L DOHC VIN R (2001)
1
With the flats of the clockspring aligned to the flats of the steering column, slide the clockspring into the steering column shaft.
2
Engage the retaining clips.
NOTE: Slight turning of the clockspring rotor is allowable for alignment purposes to the steering column.
5. Route the clockspring wire harness down the side of the steering column and into the retainers.
6. Remove the restraint system diagnostic tool from the vehicle harness side of the clockspring electrical connector.
7. Connect the two clockspring electrical connectors.
^
Position the clockspring electrical connectors onto the bracket.
8. Install the key-in-ignition warning indicator switch.
