Navigator 4WD V8-5.4L DOHC VIN R (2001)
2. Install the side impact sensor.
1
Position the side impact sensor.
2
Install the bolts.
3
Install the wire harness pin-type retainer.
4
Reposition the carpet.
3. Connect the battery ground cable.
4. With the restraint system diagnostic tools installed at all deployable devices, prove out the system.
5. Disconnect the battery ground cable and wait at least one minute.
6. Restore the vehicle to operating condition.
1
Reactivate the supplemental restraint system (SRS).
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS,
CAUTIONS, NOTES, AND INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
DEACTIVATION/REACTIVATION PROCEDURE.
2
With all the restraint system diagnostic tools removed, prove out the system. See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Air Bag(s) Arming and Disarming
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE
FROM THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE
VIOLATION OF VEHICLE SAFETY STANDARDS.
