Navigator 4WD V8-5.4L DOHC VIN R (2001)
5. Remove the brake disc.
6. Disconnect the front anti-lock brake sensor (ABS) wire assembly.
-
Disconnect the ABS electrical connector.
-
Unclip the ABS harness routing clips.
7. Remove the tie-rod castellated nut.
1. Remove and discard the cotter pin.
2. Remove and discard the castellated nut.
8. CAUTION: Do not use a hammer to separate the tie-rod from the wheel knuckle or damage to the wheel knuckle will result.
CAUTION: Do not damage the tie-rod boot when installing the special tool.
Using the special tool, separate the tie-rod end from the front wheel knuckle.
9. Using a suitable jack, support the front suspension lower arm.
10. Remove the lower ball joint castellated nut.
1. Remove and discard the coffer pin.
2. Remove and discard the castellated nut.
