Navigator 4WD V8-5.4L DOHC VIN R (2001)
Drive/Propeller Shaft: Service and Repair
Front
Driveshaft-Front
Removal and Installation
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the rear jack storage area. Failure to do so can result
in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations. Failure to follow
these instructions may result in personal injury.
With the vehicle in neutral, raise and support the vehicle.
2. Remove the front driveshaft shield.
3. Index-mark the front flange and pinion flange.
^
Repeat for the rear flange and transfer case flange.
4. Remove the four bolts retaining the rear flange to the transfer case.