Navigator 4WD V8-5.4L DOHC VIN R (2001)
Using a suitable tool as shown, disconnect the driveshaft flange yoke from the pinion flange.
6. Lower the driveshaft and slide it off the output
7. Plug the extension housing to prevent fluid loss.
8. CAUTION: Install the driveshaft with new bolts. If new bolts are not available, apply Threadlock and Sealer EOAZ-19554-AA or equivalent
meeting Ford specification WSK-M2G351-A5 to the threads of the original bolts.
CAUTION: The driveshaft flange yoke fits tightly on the pinion flange pilot. To make sure that the yoke: seats squarely on the flange, tighten the
bolts evenly in a cross pattern as shown.
To install, reverse the removal procedure.
