Navigator 4WD V8-5.4L DOHC VIN R (2001)
5. Remove the snap rings.
6. NOTE: If necessary, use a pair of pliers to remove the bearing cup if it cannot be pressed out all the way.
Remove the driveshaft slip yoke.
1
Position the driveshaft slip yoke in the C Frame & Screw.
2
Press out a bearing cup.
3
Rotate the driveshaft slip yoke.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the driveshaft slip yoke.
7. Repeat the previous step to remove the remaining bearing cups, spiders and driveshaft flange yoke from the driveshaft
8. Clean the yoke area at each end of the driveshaft.
Assembly
1. Install the bearing cup.
1
Start a new bearing cup into the driveshaft yoke.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft in the C Frame & Clamp.
4
Press the bearing cup below the yoke surface.
2. NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
Remove the driveshaft from the C Frame & Screw, and install the snap ring.
3. Repeat the two previous steps for the opposite side of the driveshaft yoke.
