Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the safety belt anchor plate with a 10.7 mm (27/64 in) drill.
3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
4. Clean out the chips.
5. Install the attachment parts. Original parts are to be replaced with the repair parts indicated in the Safety Belt Parts Replacement Guidelines.
6. When repairing a multiple belt and attachment, install the nut to the bolt in the tunnel area from the underside of the floorpan.
Safety Belt Tongue Rotated on Belt
SAFETY BELT TONGUE ROTATED ON BELT
1. Fold the safety belt as indicated.
2. Pull the safety belt tongue over the fold in the safety belt.
Safety Belt - Front Row, Center
SAFETY BELT - FRONT ROW, CENTER
Torx Bit, Safety Belt Bolt
Special Tool(s)
Removal and Installation
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height
adjusters (if so equipped) child safety seat tether attachments and attaching hardware should be inspected after any collision. All belt
assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in
use during a collision should also be inspected and replaced if either damage or incorrect operation is noted.
