Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Seat Belt Height Adjuster: Service and Repair
Safety Belt Shoulder Height Adjuster With Stripped Weld Nuts
SAFETY BELT SHOULDER HEIGHT ADJUSTER WITH STRIPPED WELD NUTS
D-Ring Installation Kit
Special Tool(s)
1. Remove the height adjuster.
2. Use the half-inch drill with integral stop provided in D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.
3. NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.
Apply a suitable lubricant to the M14x1.5 tap with integral stop provided in D-Ring Installation Kit and tap new threads.
4. Use a threaded insert provided in D-Ring Installation Kit and screw it into the retapped hole until it is slightly below the surface.