Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
Seat Belt Retractor: Service and Repair
Rear Safety Belt Retractor - Second and Third Row
REAR SAFETY BELT RETRACTOR - SECOND AND THIRD ROW
Torx Bit, Safety Belt Bolt
Special Tool(s)
Removal and Installation
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height
adjusters (if so equipped) child safety seat tether attachments and attaching hardware should be inspected after any collision. All belt
assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in
use during a collision should also be inspected and replaced if either damage or incorrect operation is noted.
NOTE: The LH side is shown, the RH side is similar.
Both retractors
1. Remove the rear quarter trim panel.
-
Before installing the third row safety belt anchor, make sure the floor slotted plastic insert is still present. If it is not, another insert must be
installed.
Third row retractor, driver side
2. Remove the vehicle jack.
Second row retractor
3. Remove the bolt and the second row safety belt retractor.
Third row retractor