Navigator 4WD V8-5.4L SOHC VIN 5 (2005)
2. NOTE: Do not allow the tire to rotate relative to the rim while mounting the tire.
Lubricate and mount the outside and inside bead of the tire to the rim.
3. NOTE: Tightening the nut to 5 Nm (44 inch lbs.) equals approximately two clockwise turns after the nut has been tightened by hand.
Push the side wall of the tire and install the tire pressure sensor. Tighten the nut.
4. CAUTION: Use only special tool 204-354 anytime tire pressures are measured to be sure that accurate values are obtained.
CAUTION: Place the air chuck straight on the valve stem to inflate the tire. Do not cock the air chuck during the inflation cycle. Doing so can
damage the valve stem and cause air leaks.
CAUTION: Ford recommends using a round head air chuck on tire pressure sensors; it is not recommended to use air chucks with long shanks.
