Navigator 4WD V8-5.4L SOHC VIN L (1998)
Ignition Key In Signal: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.
2. Remove the ignition switch lock cylinder.
1
Insert the ignition key and turn to the RUN position.
2
Press the (A) ignition switch lock cylinder release tab while pulling out the (B) ignition switch lock cylinder.
3. Remove the key in ignition warning switch.
1
Pry the clip downward.
2
Release the key-in-ignition warning switch from the rear of the ignition switch lock cylinder.
