Navigator 4WD V8-5.4L SOHC VIN L (1998)
8. Remove the disc brake anti-rattle clips.
1
Remove the pads.
2
Remove the disc brake anti-rattle clips.
INSTALLATION
1. Install the pads.
1
Install the disc brake anti-rattle clips.
2
Install the pads.
CAUTION: Do not allow grease, oil, brake fluid or other contaminants to contact the front brake pad lining material. Do not install contaminated
pads.
2. Install the disc brake caliper.
1
Install the disc brake caliper.
2
Install the disc brake caliper bolts.
CAUTION: Use care not to damage the bleeder screw or front wheel disc brake shield.
3. Clean the wheel hub mounting surface.
WARNING: ALWAYS REMOVE ANY CORROSION, DIRT OR FOREIGN MATERIAL PRESENT ON THE MOUNTING
SURFACES OF THE WHEEL OR THE SURFACE OF THE WHEEL HUB, BRAKE DRUM OR FRONT DISC BRAKE ROTOR
THAT CONTACTS THE WHEEL. INSTALLING WHEELS WITHOUT PROPER METAL-TO-METAL CONTACT AT THE
WHEEL MOUNTING SURFACES CAN CAUSE THE LUG NUTS TO LOOSEN AND COULD ALLOW THE WHEEL TO COME
OFF WHILE THE VEHICLE IS IN MOTION, CAUSING LOSS OF CONTROL.
