Navigator 4WD V8-5.4L SOHC VIN L (1998)
10. Remove the floor duct.
1. Remove the two screws (one each side).
2. Remove the floor duct.
11.
Remove the electronic blend door actuator.
1. Disconnect the connector.
2. Remove the screws.
3. Pull down to release the actuator shaft and remove the electronic blend door actuator.
Installation
1. Install the electronic blend door actuator.
1. Connect the actuator shaft.
2. Install the screws.
3. Connect the connector.
2. Install the floor duct.
1. Install the floor duct.
2. Install the two screws (one each side).
Vehicles equipped with rear airflow duct