Navigator 4WD V8-5.4L SOHC VIN L (1998)
Fuel Injector Wiring Harness: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Remove the wiring splash shield.
3. Loosen the bolts on both 42 pin fuel charging wiring electrical connectors and disconnect the connectors.
4. Disconnect the (A) 16 pin fuel charging wiring electrical connector from the (B) 16 pin engine control sensor wiring electrical connector.
NOTE: The (A) 16 pin fuel charging wiring electrical connector and the (B) 16 pin engine control sensor wiring electrical connector are located
behind the (C) mount.
