Navigator 4WD V8-5.4L SOHC VIN L (1998)
CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed two times.
2. Install a new seal on the power steering pressure hose at the power steering pump end.
-
Remove and discard the original seal.
-
Stretch the seal over the Seal Replacer until it is large enough to slip over the tube nut.
3. Install the power steering reservoir pump hose and the power steering pressure hose.
4. Position the power steering pump in the vehicle.
5. Loosely install the two bolts.
6. Raise and support the vehicle.
