Navigator 4WD V8-5.4L SOHC VIN L (1998)
21. Connect the air suspension height sensor.
22. Connect the electrical connector at the anti-lock speed sensor.
23. Lower the vehicle.
24. Turn on the air suspension control switch.
Coil Suspension
REMOVAL
1. Raise and support the vehicle.
2. Remove the rear wheel and tire assembly.
3. Mark the driveshaft flange and rear axle companion flange for correct alignment during installation.
4. Remove the four driveshaft bolts and disconnect the driveshaft and wire it out of the way.
-
Wire the driveshaft aside.
