Navigator 4WD V8-5.4L SOHC VIN L (1998)
15. Use the Differential Bearing Cone Replacer to install the new differential bearings on the differential case.
16. Measure the differential case runout without the ring gear.
-
Check the case runout again with the new differential bearings. If the runout is now at 0.076 mm (0.003 inch), use the new differential bearings
for assembly. If the runout is still excessive, the differential case is damaged and must be replaced.
INSTALLATION
1. Press the ring gear and, if removed, a new anti-lock speed sensor on the differential case.
2. Install the ring gear bolts.
-
Apply Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford specification WSK-M2G349-A1 to the ring gear bolts.
