Navigator 4WD V8-5.4L VIN 5 (2006)
Hood Latch Release: Service and Repair
Hood Latch Release Handle
HOOD LATCH RELEASE HANDLE
Removal and Installation
NOTE: The Navigator secondary hood latch release handle and cable is removed as part of the hood latch.
1. Remove the hood latch.
2. Remove the hood latch release handle and cable screw.
-
To install, tighten to 5 Nm (44 lb-ft).
3. Release the cable guides and push the cable through the dash panel and remove the hood latch release handle and cable.
4. To install, reverse the removal procedure.
