Navigator 4WD V8-5.4L VIN 5 (2006)
Trunk / Liftgate Latch: Service and Repair
Liftgate Latch Remote Control
LIFTGATE LATCH REMOTE CONTROL
Removal and Installation
NOTE: The liftgate latch remote control is available with power liftgate only.
1. Remove the liftgate trim panel.
2. Position the watershield aside.
3. CAUTION: Be careful not to kink the liftgate latch actuating cable while disconnecting it from the latch.
Disconnect the liftgate latch.
1
Release the liftgate latch actuator rod.
2
Disconnect the liftgate latch actuating cable.
4. Remove 3 bolts and position the liftgate latch remote control aside.
-
To install, tighten to 11 Nm (8 lb-in).
5. Disconnect the electrical connectors and remove the liftgate latch remote control.
6. To install, reverse the removal procedure.