Navigator 4WD V8-5.4L VIN 5 (2006)
22. Disconnect the power lumbar and seat control switch electrical connectors and remove the cushion side shield.
Outboard seat track
23. Remove the 4 outboard seat track nuts and the outboard seat track.
Installation
Outboard seat track
1. Position the outboard seat track and install the 4 nuts.
-
Tighten to 35 Nm (26 lb-ft).
8-way power seat
2. Position the cushion side shield and connect the power lumbar and seat control switch electrical connectors.
3. Push to install the 3 cushion side shield retainers onto the seat frame.
4. Access and install the cushion side shield front screw.
5. Install the power recline and seat control switch knobs.
6-way power seat
6. Position the cushion side shield and install the center and rear retainers into the seat frame.
7. Install the cushion side shield front screw.
8. Install the seat control switch knob.
9. Install the cushion side shield screw from under the manual lumbar knob.
10. Align and install the manual lumbar knob.
11. Position the recliner handle and install the screw and cover.
12. Connect the seat control switch electrical connector.
Outboard seat track
13. Install the forward/reverse power seat motor outboard drive cable to the outboard seat track.
Inboard seat track
14. Position the inboard seat track to the seat frame and install the cushion frame-to-inboard seat track bolt.
-
Tighten to 47 Nm (35 lb-ft).
15. Install the 4 cushion frame-to-inboard seat track nuts.
-
Tighten to 35 Nm (26 lb-ft).
16. Position the safety belt buckle and pretensioner to the bracket and install the nut.
-
Tighten to 40 Nm (30 lb-ft).
17. Connect the safety belt buckle pretensioner and usage detection electrical connectors.
