Navigator 4WD V8-5.4L VIN 5 (2006)
Rear Brake Disc Components
Disassembly
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. Remove the disc brake caliper.
2. Drain the remaining brake fluid from the disc brake caliper.
3. Secure the disc brake caliper in a vise.
4. Remove the caliper piston.
^
Place a block of wood between the caliper bridge and the caliper piston.
^
Apply low air pressure to the fluid port in the disc brake caliper.
^
Force out the caliper piston to the block of wood.
^
Remove the block of wood and the caliper piston.
