Navigator 4WD V8-5.4L VIN 5 (2006)
8. Position the Y-pipe and install the 4 nuts.
^
Tighten to 40 Nm (30 ft. lbs.).
9. Position the sway bar and install the 4 bolts.
^
To install, tighten to 30 Nm (22 ft. lbs.).
10. Remove the special tools.
11. If installing the LH engine mount, install the oil level indicator and tube.
12. If installing the RH engine mount, install the starter. For additional information, refer to Starter.
13. Install the upper cooling fan shroud. For additional information, refer to Cooling System.
14. Install the generator. For additional information, refer to Alternator.
15. Install the air cleaner housing. For additional information, refer to Fuel Delivery and Air Induction.
16. Connect the battery ground cable. For additional information, refer to Battery.
