Navigator 4WD V8-5.4L VIN 5 (2006)
Remove all of the remaining roller followers from the cylinder heads.
Installation
1. Install the LH and RH camshafts.
^
Lubricate the camshaft and camshaft journals with clean engine oil prior to installation.
2. NOTE: LH shown, RH similar.
Install the LH and RH camshaft bearing caps in their original locations.
^
Lubricate the camshaft bearing caps with clean engine oil.
^
Position the front camshaft bearing cap.
^
Position the remaining camshaft bearing caps.
^
Install the bolts loosely.
^
Tighten to 10 Nm (89 inch lbs.). in the sequence shown.
3. CAUTION: Damage to the camshaft phaser sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
NOTE: LH shown, RH similar.
Install the camshaft phaser sprockets and new camshaft phaser bolts finger tight.
