Navigator 4WD V8-5.4L VIN 5 (2006)
3. CAUTION: Overtightening the tire pressure sensor valve stem nut can damage the tire pressure sensor, undertightening can cause air leaks.
NOTE: Sensor position is critical for correct sensor operation. The "flat" side of the sensor must be facing the wheel and the "slanted" side of the
sensor must be facing away from the wheel. When properly installed, there will be a very small gap between the sensor and the wheel.
NOTE: Tightening the nut to 5 Nm (44 inch lbs.) equals approximately 2 clockwise turns after the nut has been tightened by hand.
Push the side wall of the tire and install the tire pressure sensor. Tighten the nut to 5 Nm (44 inch lbs.).
4. CAUTION: Use only special tool 204-354 anytime tire pressures are measured to be sure that accurate values are obtained.
CAUTION: Place the air chuck straight on the valve stem to inflate the tire. Do not cock the air chuck during the inflation cycle. Doing so can
damage the valve stem and cause air leaks.
