Navigator 4WD V8-5.4L VIN 5 (2006)
Desired Camber Adjustment (In Degrees) (Part 2)
4. Use the following table to determine the camber adjustment required. Obtained by subtracting the specified camber angle from the measure
camber angle.
5. Remove the upper arm-to-knuckle nut and install a new one until snug.
6. NOTE: Support the vehicle at the lower arm to ease the wheel knuckle movement in the upper arm slot.
Position the upper arm-to-knuckle bolt in the upper arm slot as required to adjust the camber angle to the value obtained in Step 4.
7. Tighten the upper arm-to-knuckle nut to 150 Nm (111 ft. lbs.).
8. Recheck the camber setting, adjust as necessary.
9. Check and, if necessary, adjust the rear toe.
