Navigator 4WD V8-5.4L VIN 5 (2006)
16. Remove the bolt and the heat shield.
17. Remove the nuts and the remaining line brackets.
18. NOTE: If installing only one auxiliary evaporator line, cut only the desired line.
Assemble and lay out the replacement line(s) in the same position as the existing line(s) and, using a suitable tool, cut the auxiliary evaporator
line(s) in the same position as the fittings on the new line(s).
19. Remove the auxiliary evaporator line(s) in 3 separate pieces.
Installation
1. Partially lower the vehicle to allow access to both the rear auxiliary line fittings and the underside of the vehicle.
2. Position the rear portion of the auxiliary evaporator line(s) and install the line bracket and bolts.
