Navigator 4WD V8-5.4L VIN 5 (2006)
-
Disconnect the quick connect fitting.
Connect - Type 2
CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
NOTE: If the fuel tube retainer clip is broken or damaged, install a new clip using a suitable fuel line disconnect tool to separate the retaining clip legs.
Once the retainer legs have been separated, lift the clip out of the connector housing, lifting from the stamped side of the connector body.
1. NOTE: Apply clean engine oil to the end of the tube or fitting before connecting.
Connect the tube into the quick connect fitting.
2. CAUTION: Make sure the quick connect fitting clicks into place when installing the tube. To make sure that the quick connect fitting is
fully seated, pull on the fitting.
Press the locking tab down into the locked position.
