Navigator 4WD V8-5.4L VIN 5 (2006)
Power Trunk / Liftgate Control Module: Service and Repair
POWER LIFTGATE MODULE
Removal and Installation
NOTE: Prior to removal of the power liftgate module, it is necessary to upload module configuration information to a diagnostic tool. This information
needs to be downloaded into the new power liftgate module once installed.
1. Remove the rear quarter trim panel.
2. Remove the power liftgate module.
1
Disconnect the electrical connectors.
2
Remove the nut.
-
To install, tighten to 11 Nm (8 lb-ft).
3. NOTE: Once the new power liftgate module is installed, it is necessary to download the module configuration information from the diagnostic
tool into the new power liftgate module.
To install, reverse the removal procedure.