Navigator 4WD V8-5.4L VIN 5 (2006)
Seat Belt Buckle: Service and Repair
Safety Belt Buckle - Second Row, 40 Percent Seat
SAFETY BELT BUCKLE - SECOND ROW, 40 PERCENT SEAT
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS], if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
NOTE: RH 40 percent seat shown, LH similar.
1. Pivot the 40 percent seat upward.
2. Remove the 2 screws and the seat side shield.
3. Remove the screw and the lower pedestal cover.
4. Remove the bolt and the safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
5. NOTE: When installing the safety belt buckle, make sure to engage the anti-rotation tab to the seat frame.
To install, reverse the removal procedure.
6. Check the active restraint system for correct operation.
