Navigator 4WD V8-5.4L VIN 5 (2006)
12. Invert the seat backrest cover and remove the 2 pin-type retainers.
13. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the seat backrest foam.
Remove the seat backrest cover.
14. Remove the seat backrest foam pad.
15. Remove the 6 seat backrest support panel screws.
16. Remove the 2 safety belt retractor cover screws and remove the cover.
17. Remove the safety belt retractor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
18. Pinch and release the safety belt retractor guide from the seat backrest frame and remove the safety belt retractor.
19. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
When installing the safety belt retractor, make sure to engage the anti-rotation tab to the sheet metal.
-
Remove the shipping clip after safety belt retractor installation.
To install, reverse the removal procedure.
20. Check the active restraint system for correct operation.