Navigator 4WD V8-5.4L VIN 5 (2006)
4. Release the hook-and-loop strip and pull the seat cushion trim cover up enough to expose the safety belt buckle and pretensioner.
5. NOTE: Make note of the wire harness routing for installation.
Remove the safety belt buckle and pretensioner electrical connectors from the seat cushion frame.
-
Disconnect the usage detection switch electrical connector.
-
Separate the safety belt buckle pretensioner electrical connector from the pin-type retainer.
6. Remove the nut and the safety belt buckle and pretensioner.
-
To install, tighten to 40 Nm (30 lb-ft).
7. To install, reverse the removal procedure.
8. Install the 40 percent front seat.
9. Repower the SRS.
10. Check the active restraint system for correct operation.
60 Percent Seat
SAFETY BELT BUCKLE AND PRETENSIONER - 60 PERCENT SEAT
