Navigator 4WD V8-5.4L VIN 5 (2006)
5. Strip the wires near the electrical connector.
6. Obtain 2 wires (20 gauge minimum) at least 6.1 meters (20 feet) long and attach one end of each wire to the safety belt buckle pretensioner wires.
7. Position the safety belt buckle pretensioner assembly on a flat surface in an open outdoor area so that moveable parts do not contact the support
surface.
8. Remain at least 6.1 meters (20 feet) away from the safety belt buckle pretensioner assembly.
9. Deploy the safety belt buckle pretensioner by touching the other ends of the 2 wires to the terminals of a 12-volt battery.
10. To allow for cooling, wait at least 10 minutes before approaching the deployed safety belt buckle pretensioner.
11. Dispose of the deployed safety belt buckle pretensioner in the same manner as any other part to be scrapped.
