Navigator 4WD V8-5.4L VIN 5 (2006)
3. Depress the tabs and detach the parking brake cable from the wheel knuckle.
4. Remove the toe link-to-wheel knuckle nut and detach the toe link from the wheel knuckle.
^
Discard the nut.
^
To install, tighten to 55 Nm (41 ft. lbs.).
5. Remove the upper arm-to-wheel knuckle nut and bolt.
^
Discard the nut.
^
To install, tighten to 150 Nm (111 ft. lbs.).
6. Remove the lower arm-to-wheel knuckle nut, bolt and the wheel knuckle.
^
Discard the nut.
^
To install, tighten to 400 Nm (295 ft. lbs.).
7. If necessary, using a suitable press and adapters, remove the wheel knuckle bushing.
8. To install, reverse the removal procedure.
9. Check and, if necessary, adjust the rear alignment.