Navigator 4WD V8-5.4L VIN 5 (2006)
Fluid Filter - A/T: Service and Repair
Transmission Fluid In-Line Filter - Without an OTA Cooler
4R70E/4R75E Automatic Transmission
Transmission Fluid In-line Filter - without an OTA cooler
NOTE: Use the following guidelines for installing the transmission fluid in-line filter:
^
If the transmission was overhauled and the vehicle was equipped with an in-line fluid filter, install a new in-line fluid filter.
^
If the transmission was overhauled and the vehicle was not equipped with an in-line fluid filter, install a new in-line fluid filter kit.
^
If the transmission is being installed for a non-internal repair, do not install an in-line filter or filter kit.
^
If installing a new or a Ford-authorized remanufactured transmission, install the in-line transmission fluid filter that is supplied.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the cooler tubes retainers.
3. Remove the section of the steel tube as illustrated.
^
Clean and de-burr the end of the steel tubes.
4. NOTE: Be sure the cooler tube is fully seated in the body of the fitting before final tightening of the ferrule nut.
Install the tubing ferrule hose assembly connector onto the end of the steel fluid cooler tubes. Finger-tighten the ferrule nut, then tighten the nut an
additional 1-1/2 turns to seat the ferrule in the connector.
