Navigator 4WD V8-5.4L VIN 5 (2006)
3.
Position a drain pan under the transmission, then remove and discard the transmission fluid pan drain plug. Allow the fluid to drain, then install a
new drain plug. Tighten the plug to 8 Nm (71 lb-in).
4.
Remove the transmission fluid pan.
5.
CAUTION: Do not use any type of solvent when cleaning the oil pan. The transmission filter is an integral part of the pan and may become
contaminated if solvents are used. Use only a clean rag to wipe the pan and gasket clean.
Remove, clean and inspect the oil pan gasket. Also wipe the pan rail and case rail dry of any fluid.
6.
Install the pan gasket. Be sure to properly seat the gasket in the groove, aligning the flat tab on the gasket with the flat indentation on the pan.
7.
Inspect the filter stand pipe 0-ring on the oil pan. Make sure there is no damage to the 0-ring.
8.
Remove the park pawl guide plate bolts and remove the plate from the transmission. See Figure 1.
9.
Position the new plate, making sure to properly align the locating tab, then install the bolts. Tighten the bolts to 10 Nm (89 lb-in).
10.
Install the fluid pan and bolts. Tighten the bolts in a crisscross pattern to 11 Nm (97 lb-in).
