Navigator 4WD V8-5.4L VIN 5 (2006)
6. Position the output shaft seal.
7. Using the special tool, install a new output shaft seal.
8. Install the extension housing and the 11 bolts.
^
Tighten to 48 Nm (35 ft. lbs.).
9. Install the transfer case.
All vehicles
10. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
11. With the engine idling (600 - 750 rpm) in PARK and the transmission temperature at 30°C - 50°C (86°F - 122°F), check and adjust the
transmission fluid level.
12. CAUTION: The fluid fill plug located on the side of the transmission is near the exhaust system. The exhaust will be extremely hot during this
procedure. Use care when working near the exhaust and the heat shields.