Navigator 4WD V8-5.4L VIN 5 (2006)
11. Install the transmission fluid pan. Tighten the bolts in a crisscross pattern.
^
Tighten to 8 Nm (71 inch lbs.).
12. Install the shift cable bracket bolts and connect the shift cable end.
^
Tighten to 48 Nm (35 ft. lbs.).
13. Connect the main transmission electrical harness by pushing it in and twisting the outer shell to lock it in place.
14. CAUTION: The fluid fill plug located on the side of the transmission is near the exhaust system. The exhaust will be extremely hot during this
procedure. Use care when working near the exhaust and the heat shields.
Remove the fluid fill plug.
^
The fill plug is located on the RH rear side of the case near the transmission electrical connector.
