Navigator 4WD V8-5.4L VIN 5 (2006)
4. Slide the driveshaft back enough to index-mark the driveshaft, the extension housing and the output shaft. Separate the driveshaft from the
transmission.
4x4 vehicles
5. Remove the transfer case.
All vehicles
6. Use the high-lift jack to support the transmission.
7. NOTE: RH shown, LH similar.
Remove the 2 bolts retaining the heat shield to the transmission support crossmember.
8. Loosen, but do not remove the transmission-to-crossmember nuts.
9. Remove the crossmember-to-frame bolts.
