Navigator 4WD V8-5.4L VIN 5 (2006)
Special Tools
Removal
CAUTION: Use care not to damage the manual control lever shaft bore. The new seal can leak.
CAUTION: Discard the outer manual control lever nut.
NOTE: When removing the manual control lever shaft retaining pin, use a soft cloth to protect the surface of the case.
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
4x4 vehicles
2. Remove the front driveshaft shield nuts and remove the shield.
3. NOTE: Index-mark the front and rear flange.
NOTE: It is not necessary to remove the front driveshaft from the vehicle.
Index-mark the front and rear flange, disconnect the front driveshaft and position aside.