Navigator 4WD V8-5.4L VIN 5 (2006)
8. CAUTION: Do not touch the electrical connector pins. Electrostatic charge may occur and will cause damage to the mechatronic unit.
Pull the outer shell of the bulkhead electrical connector out of the transmission.
9. Remove the 10 bolts from the mechatronic assembly and remove the mechatronic assembly.
Installation
1. Position the mechatronic assembly in place and loosely install the 10 retaining bolts.
2. Tighten the mechatronic bolts in the sequence shown.
^
Tighten to 8 Nm (71 inch lbs.).
