Navigator 4WD V8-5.4L VIN 5 (2006)
Axle Shaft Assembly: Service and Repair
Removal and Installation
Front Drive Halfshafts
Halfshaft
Removal and Installation
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the left rear quarter trim panel. Failure to do so can
result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the front wheel and tire assembly.
3. Remove the dust cap.
4. Remove and discard the axle nut.
^
To install, tighten to 27 Nm (20 ft. lbs.).
5. Remove the vacuum/vent line at the vacuum/vent port of the integrated wheel end disconnect.
