Navigator 4WD V8-5.4L VIN 5 (2006)
6. Remove the 3 integrated wheel end (IWE) retaining bolts to the steering knuckle.
^
To install, tighten to 12 Nm (9 ft. lbs.).
7. Remove the tie-rod end nut.
^
Disconnect the tie-rod end from the steering knuckle.
^
Discard the tie-rod end nut.
^
To install, tighten to 150 Nm (111 ft. lbs.).
8. Remove the upper ball joint nut.
^
Disconnect the upper ball Joint from the steering knuckle.
^
Discard the upper ball joint nut.
^
To install, tighten to 150 Nm (111 ft. lbs.).
9. CAUTION: Do not damage the hub seal.
NOTE: Allow the steering knuckle to swing outboard while keeping the constant velocity shaft pushed inboard.