Navigator 4WD V8-5.4L VIN 5 (2006)
5. Disconnect the toe link from the rear knuckle.
^
To install, tighten to 55 Nm (41 ft. lbs.).
6. Remove the bolt retaining the knuckle to the lower control arm.
^
To install, tighten to 400 Nm (295 ft. lbs.).
7. Pivot the rear knuckle on the upper control arm bolts and support the knuckle in a raised position.
8. CAUTION: Do not damage the axle shaft oil seal or the machined sealing surface on the inboard CV joint housing.
CAUTION: Do not allow the splines on inboard CV joint housing to touch the axle shaft oil seal.
NOTE: A circlip retains the inboard CV joint housing to the differential side gear in the axle.
Using the special tool, disengage the inboard CV joint housing from the differential side gear.
