Navigator 4WD V8-5.4L VIN 5 (2006)
12. Remove the outboard boot.
13. NOTE: If the grease is contaminated, clean and inspect the joint for wear. Install a new outboard CV Joint and interconnecting shaft assembly if
worn/damaged.
Check the grease for contamination.
Assembly
1. Position the outboard boot on the shaft.
2. Pack the outboard CV Joint with 165 grams (5.82 ounces) of grease.
1
Use constant velocity joint grease or equivalent provided in the boot kit.
2
Spread any remaining grease from the kit evenly inside the boot.
3. Install the outboard boot.
