Navigator 4WD V8-5.4L VIN 5 (2006)
6. NOTE: The outboard CV joint is not removable from the halfshaft. The boot must be removed or installed from the inboard CV joint side of the
shaft.
For the outboard CV joint, carry out the following:
1
Remove and discard the boot clamps.
2
Remove and discard the boot.
7. Inspect the grease, packed in the inboard CV joint and the outboard CV Joint, for contamination. Rub some of the grease from each joint between
2 fingers. Any gritty feeling indicates contamination. Wash all of the grease from the inboard CV joint, the inboard CV joint housing, the outboard
CV Joint and the interconnecting shaft. Thoroughly dry all of the components and inspect them for wear or damage.
Discard the assembly, if necessary. Only proceed as follows if not discarding the assembly.
8. On the inboard end, remove and discard the retainer circlip.
Assembly
1. NOTE: Clean any excess grease from the boot mounting surfaces before installing the boot.
For the outboard CV joint, carry out the following:
1
Slide the boot on the interconnecting shaft.
2
Pack the outboard CV joint with 275 grams (9.7 ounces) of grease.
3
Spread any remaining grease evenly inside the boot.
4
Install the boot by seating it in the groove in the CV joint housing.
