Navigator 4WD V8-5.4L VIN 5 (2006)
Wheel Bearing: Service and Repair
Wheel Bearing and Wheel Hub
Removal and Installation
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle.
This can be accomplished by turning off the air suspension switch located in the LH rear quarter trim panel. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations. Failure to follow these
instructions may result in personal injury.
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major
service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser
quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
1. If equipped, turn the air suspension switch to the OFF position.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. NOTE: Have an assistant press the brake pedal to keep the axle from rotating.
Remove and discard the rear halfshaft nut and washer.
^
To install, tighten to 300 Nm (221 ft. lbs.).
