Navigator 4WD V8-5.4L VIN 5 (2006)
4. Using a suitable hub puller, separate the outboard CV Joint from the wheel hub.
5. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can result.
Remove the bolts and position the caliper aside.
^
Support the caliper using mechanic's wire.
^
To install, tighten to 190 Nm (140 ft. lbs.).
6. Remove the brake disc.
7. Disconnect the wheel speed sensor electrical connector and detach the wheel speed sensor harness from the retainer.
8. Remove the bolt and detach the harness from the retainers. To install, tighten the bolt to 15 Nm (11 ft. lbs.).
9. Remove the 4 wheel bearing and hub assembly bolts, the wheel bearing assembly and the wheel speed sensor as an assembly.
^
Route the sensor wiring through the access hole in the brake shield.
^
Discard the bolts.
^
To install, tighten to 185 Nm (136 ft. lbs.).
10. If necessary, remove the wheel speed sensor bolt and the wheel speed sensor from the wheel bearing and hub assembly.
^
To install, tighten to 15 Nm (13 ft. lbs.).
11. To install, reverse the removal procedure.
