Navigator 4WD V8-5.4L VIN 5 (2006)
Wiper Arm: Service and Repair
Wiper Pivot Arm - Rear
WIPER PIVOT ARM - REAR
Removal
1. CAUTION: Use a shop towel or similar device to protect the vehicle finish when carrying out the procedure.
Remove the rear window wiper pivot arm.
1
Lift the pivot arm nut cover.
2
Remove the nut.
Installation
1. NOTE: This step makes sure that the wiper motor is in the PARK position.
Turn the rear window wiper switch ON and allow the motor to operate for at least one cycle. Turn the rear window wiper switch to OFF.
2. Install the rear window wiper pivot arm onto the rear window wiper motor shaft.
1
Position the wiper pivot arm within specification.
2
Tighten the nut to 15 Nm (11 lb-ft).
3
Install the cover.