Town Car V8-281 4.6L SOHC (1991)
2.
Pry demister grille below bottom vent opening with small screwdriver, then slide down to disengage upper hook. Refer to Figures 1 and 2.
3.
Remove any loose (foam) debris or sticky glue residue from the area to be glued by scraping or rubbing with steel wool.
4.
Apply a bead of instant adhesive for entire length of separation between substrate and soft cover as required. Refer to Figure 3.
5.
Position soft trim cover into place and apply pressure for a minimum of 30 seconds, or until set. Soft cover edge should align with substrate edge.
Refer to Figure 4.
6.
Repeat this procedure for other side of vent opening.
